Last updated: August 2026
GORTEF supplies PTFE-coated fusing belts to fit the Oshima OP-1000NE, made to the dimensions you measure off your own machine. It is an aftermarket replacement rather than a genuine OSHIMA Taiwan Co. Ltd. part.
The OP-1000NE runs a nine zone PID heating system, which holds temperature more evenly across the width than an older single zone machine. That makes belt condition the limiting factor rather than the heaters: a belt with a worn patch shows up as an inconsistent bond even though the temperature still reads correctly.
Confirming the Exact Specification
We are still finalising the published dimensions for this model. Send us the dimensions of the belt you are removing, or a photo of it alongside its packaging, and we will confirm the construction before you order. Measure the old belt itself where you can. Working back from the machine aperture or the roller centres gives a length that is close but rarely exact.
How to Order a Belt for the Oshima OP-1000NE
Measure the belt across its width and right around its length, and tell us how the ends are joined. We make PTFE belts endless to the length you measure and finish the edges to suit the way your machine tracks them.
If the old belt is already off the machine, measure it flat and send a photo of the join with your dimensions. The join type matters as much as the length for how a belt runs.
Check You Have the Right Machine
Model designations vary between regions and production years. To confirm the Oshima OP-1000NE is the machine you are servicing, check the manufacturer's own listing:
Oshima OP-1000NE on the manufacturer's siteOshima and OP-1000NE are trademarks or model designations of OSHIMA Taiwan Co. Ltd. GORTEF is not affiliated with, endorsed by or sponsored by OSHIMA Taiwan Co. Ltd. All names and part numbers are used for identification and cross-reference only, and every GORTEF product described here is an aftermarket replacement product rather than a genuine manufacturer part.
