Last updated: August 2026
GORTEF supplies PTFE-coated fusing belts to fit the Macpi 327.00, made to the dimensions you measure off your own machine. It is an aftermarket replacement rather than a genuine Macpi S.p.A. part.
The Macpi 327.00 is the shirt machine in the range, 1000mm working width, built for collars and cuffs fed and unloaded from the same side. Shirt work runs hot and in high volume, so belts on a 327 are usually changed on a shorter interval than on a jacket line.
Confirming the Exact Specification
We are still finalising the published dimensions for this model. Send us the dimensions of the belt you are removing, or a photo of it alongside its packaging, and we will confirm the construction before you order. Measure the old belt itself where you can. Working back from the machine aperture or the roller centres gives a length that is close but rarely exact.
How to Order a Belt for the Macpi 327.00
Measure the belt across its width and right around its length, and tell us how the ends are joined. We make PTFE belts endless to the length you measure and finish the edges to suit the way your machine tracks them.
If the old belt is already off the machine, measure it flat and send a photo of the join with your dimensions. The join type matters as much as the length for how a belt runs.
Check You Have the Right Machine
Model designations vary between regions and production years. To confirm the Macpi 327.00 is the machine you are servicing, check the manufacturer's own listing:
Macpi 327.00 on the manufacturer's siteMacpi and 327.00 are trademarks or model designations of Macpi S.p.A. GORTEF is not affiliated with, endorsed by or sponsored by Macpi S.p.A. All names and part numbers are used for identification and cross-reference only, and every GORTEF product described here is an aftermarket replacement product rather than a genuine manufacturer part.
