Last updated: August 2026
GORTEF supplies PTFE-coated fusing belts to fit the Kannegiesser MultiStar DX, made to the dimensions you measure off your own machine. It is an aftermarket replacement rather than a genuine Herbert Kannegiesser GmbH part.
The MultiStar DX is the modular machine in the same Kannegiesser fusing family as the CX, built to order, so working width varies between installations. Do not assume a DX belt matches another site's DX belt: measure the machine in front of you.
Confirming the Exact Specification
We are still finalising the published dimensions for this model. Send us the dimensions of the belt you are removing, or a photo of it alongside its packaging, and we will confirm the construction before you order. Measure the old belt itself where you can. Working back from the machine aperture or the roller centres gives a length that is close but rarely exact.
How to Order a Belt for the Kannegiesser MultiStar DX
Measure the belt across its width and right around its length, and tell us how the ends are joined. We make PTFE belts endless to the length you measure and finish the edges to suit the way your machine tracks them.
If the old belt is already off the machine, measure it flat and send a photo of the join with your dimensions. The join type matters as much as the length for how a belt runs.
Kannegiesser and MultiStar DX are trademarks or model designations of Herbert Kannegiesser GmbH. GORTEF is not affiliated with, endorsed by or sponsored by Herbert Kannegiesser GmbH. All names and part numbers are used for identification and cross-reference only, and every GORTEF product described here is an aftermarket replacement product rather than a genuine manufacturer part.
